PSC RF Multi Mini Antenna Distribution

Share

The PSC RF Multi Mini contains two, separate, active 1 x 3 RF splitters for use with up to three diversity receivers. This compact, rugged device was developed using the latest super low noise, high current RF amplifiers and will operate over various frequency ranges based on which bandpass filter it is built with.

Its two inputs are traditional BNC connectors for ease of use in interfacing with your external antennas. The PSC RF Multi Mini also can provide power to external powered antennas or remote line amplifiers. Each of the SMA outputs offers a typical isolation factor of 24 to 28dB between radio receivers.

A three-way switch is located on the top panel between the two BNC RF inputs. This switch has three positions: "OFF", main power "ON", and main power and remote ANTENNA PWR switched on. The switch utilizes a light-up LED switch handle. When used in normal mode, the switch battery lights up GREEN. When the unit is switched to also provide remote antenna power, the switch lights up RED. The entire unit is powered from any source of external DC power of 7 to 18Vdc @ approximately 120 mA.

PSC RF Multi Mini Antenna Distribution - Features:

• Diversity 1 x 3 active RF splitter
• Low noise, high current RF amplifiers
• Compact package
• Made in the USA
• LSC stocks Single Band (470-700 Mhz) and Wide Band (470-960 Mhz)

• Power: External DC, 7-18Vdc @ 120mA
• Frequency Range:
  • 470-700 Mhz (Single Band Model)
  • 470-618Mhz & 940-960Mhz (Dual Band Model)
  • 470-960Mhz (Wide Band Model)
• Input Impedance: 50 Ohms
• Output Impedance: 50 Ohms
• Max Input Signal Before Limiting: +13dB
• IP3: +31
• Noise Figure: 0.8dB
• Chassis Material: Aircraft Aluminum
• End Plate Material: Stainless Steel
• Finish: Black Anodize
• Housing Size: 3.2 x 2.1 x 0.9 in | 81 x 53 x 23 mm
• Weight: 172 g | 6 oz